|
|
|
|
Description:
|
adslPortOps OBJECT-TYPE
SYNTAX INTEGER
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"The managed object is for ADSL line configuration. When the EMS
wants to issue the desired operation, the EMS shall send SNMP-SET message to set
the corresponding bit value to be 1. The various bit positions are:
BIT 1: enable port
BIT 2: disable port
BIT 3: set ADSL mode
BIT 4: set line profile
BIT 5: set alarm profile
BIT 6: enable Annex L to be narrow mode
BIT 7: enable Annex L to be wide mode
BIT 8: disable Annex L
BIT 9: enable Annex M
BIT 10: disable Annex M
BIT 11: enable Annex I
BIT 12: disable Annex I
BIT 13: set option mask
BIT 14: enable power management mode to be L2
BIT 15: enable power management mode to be L3
BIT 16: disable power management mode
BIT 17: set power mode to be fixed
BIT 18: set power mode to be priority to power
BIT 19: set power mode to be priority to rate
BIT 20: set ATU-R max Tx power
BIT 21: set ATU-C max Tx power
BIT 22: set max Rx power
BIT 23: set ATU-R carrier mask
BIT 24: set ATU-C carrier mask
BIT 25: set ATU-R INP minimum setting
BIT 26: set ATU-C INP minimum setting"
|
|
Disclaimer: The owner of this site does not warrant or assume any liability or responsibility for the accuracy, completeness, or usefulness of any information available on this page (for more information, please read the complete disclaimer).
All rights reserved © 2007-2024 |
iso(1)
