|
|
Description:
|
sts1MaprCmdStatus OBJECT-TYPE
SYNTAX LinkCmdStatus
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"The command status for this link configuration row/record.
The value used in a SET will be replaced by a response
value in the GET RESPONSE indicating success or failure.
Default Response State used in GET RESPONSE Command
ready-for-command (0)
initial default status for a row
STS1 Link Commands used in SET Command (1..199)
update-link-config(1),
Change existing Link Configuration
Response States used in GET RESPONSE Command (200..399)
update-successful (201)
Link data has been successfully changed
STS1 Mapper Config Error Codes used in GET RESPONSE Command (400..699)
err-general-link-config-error (400)
Unknown link configuration error occurred
err-invalid-link-status (401)
Unrecognized link status setting
err-invalid-link-framing (402)
Line framing type not valid for link type
err-invalid-link-command (403)
Unrecognized link command-action
err-invalid-link-op-mode (407)
Configured M13 Op mode not valid for port; verify other
link parameters match desired new mode
err-invalid-link-rem-loop (408)
Remote Loop type not valid for sts1 frame type
err-invalid-link-ais (409)
Unrecognized sts1 AIS selection
err-data-locked-by-another-user (450)
Another administrative user is making changes to this
part of the system via a terminal session. Check Event
Log for user name
err-snmp-parse-failed (500)
Agent could not parse variable
err-invalid-snmp-type (501)
Variable ASN type does not match Agent defined type
err-invalid-snmp-var-size (502)
Variable size is too big"
|
|
|
|
|
|