Main page
OID Repository
https://oid-base.com
Display OID:

{iso(1) identified-organization(3) dod(6) internet(1) private(4) enterprise(1) 644 eriProducts(2) dnx(4) sysMgr(1) resourceTable(1) resourceEntry(1) resourceState(4)}

resourceState(4)

 
 

OID description



 
OID: (ASN.1 notation)
(dot notation)
(OID-IRI notation)

Description:

resourceState OBJECT-TYPE
SYNTAX UnsignedInt
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"Gives the state of the object. This is a bitmap whose exact meaning depends on the resource type. Bit zero refers to the rightmost bit.
The following bits are RESERVED for ALL types.
bit 0 No Alarm
bit 25 Config Error
bit 26 Can't be Clock Source
bit 27 Error Counter Non Zero
bit 28 Rear card not present
bit 29 Clock source
bit 30 In test
bit 31 Out of service
NOTE: This does not mean that these bits could be set by all types only that the individual types will not define another bit in the same place.
-- Long description deleted.
Type portE3
bit 0 No Alarm (common)
bit 1 Rcv far end LOF (yellow alarm)
bit 2 Near end sending LOF
bit 3 Receiving AIS
bit 4 Near end sending AIS
bit 5 Near end LOF (red alarm)
bit 6 Near end loss of signal
bit 7 Near end is looped
bit 9 Far end receive failure
bit 11 Near end detected test code
bit 12 Other line status
bit 13 Near end unavailable signal
bit 14 Carrier equipment out of service
bit 15 Near end sever errored frame
bit 16 Rx/Tx clock failure
bit 17 Tx far end block error
bit 22 LIU Drive Monitor error
bit 23 LIU coding violation
bit 24 LIU FIFO error
bit 25 through 31 Reserved as Common
Finished."



Classification:

MIB object for network management

 
See classes of OIDs

Note to implementers:




 
 
Short link:


Parent OID: resourceEntry(1) First sibling OID: resourceKey(1) Previous sibling OID: resourceType(3) Next sibling OID: resourceCriticalMask(5) Last sibling OID: resourceTrapMask(10)