|
|
Description:
|
frUniDnaOutDefaultPathReliability OBJECT-TYPE
SYNTAX INTEGER {
high(0),
normal(1) }
ACCESS read-write
STATUS mandatory
DESCRIPTION
"This attribute specifies the default class of routing for reliability
routing for all outgoing calls (from the DTE to the network) using
this particular DNA. The chosen default class of routing applies to
all outgoing calls established using this DNA, and applies to the
packets travelling in both directions on all outgoing calls (local to
remote, and remote to local). For incoming calls, the default class of
routing is chosen by the calling party (as opposed to DPN, where
either end of the call can choose the default routing class).
This attribute, if set to a value of normal, indicates that the default
class of routing is normal reliability routing. If set to a value of
high, then the default class of routing is high reliability routing.
High reliability is the standard choice for most DPN and Passport
services. It usually indicates that packets are overflowed or
retransmitted at various routing levels. Typically high reliability
results in duplication and disordering of packets in the network
when errors are detected or during link congestion. However, the
VC handles the duplication and disordering to ensure that packets
are delivered to the DTE properly.
For the Frame Relay service, duplication of packets is not desired,
in which case, normal reliability may be chosen as the preferred
class of routing."
DEFVAL { normal }
|
|
|
|
