|
|
Description:
|
dlDownloadDevice OBJECT-TYPE
SYNTAX INTEGER
ACCESS read-write
STATUS mandatory
DESCRIPTION
"This object defines the device which is to have firmware
downloaded.
A value of 1 specifies the transponder. A value of 2 to 256
specifies TIB devices 1 to 255. Values of dlDownloadDevice
greater than 256 may be used for non-TIB devices managed by
the transponder.
This indexing scheme is used to avoid using an index value of 0
to identify the transponder. This indexing scheme matches that of
dlTransponderTable.
Not all transponders support TIB based devices.
There are no restrictions on the value of this object.
When dlDownloadControl is set to initiate(1), an invalid value
for dlDownloadImage results in the inability to set dlDownloadControl.
This value for this object reverts back to 0 after the end of
any download or download error. As valid indices begins at 1,
this provides some added security to prevent accidental erasure.
The value of this object should only be changed when
dlDownloadStatus is done(6). Attempts to change object during any other
state results in termination of the download in progress and an
error being recorded. The actions associated with detecting an error
are described by Note 4 of the download state diagram presented
earlier in the document. The object value will not be cleared and
the new value shall be accepted.
The dlDownloadKey does not affect this object.
The default value is 0. This object is volatile."
|
|
Disclaimer: The owner of this site does not warrant or assume any liability or responsibility for the accuracy, completeness, or usefulness of any information available on this page (for more information, please read the complete disclaimer).
All rights reserved © 2007-2024 |