|
|
Description:
|
v52ProtectionCPathTable OBJECT-TYPE
SYNTAX SEQUENCE OF V52ProtectionCPathEntry
MAX-ACCESS not-accessible
STATUS current
DESCRIPTION
"This table is read-only and is derived from the protection
group provisioning information from the v52CChannelTable.
Unlike the C-Paths defined in v52CPathTable, C-Paths for the
protection protocol are not carried over logical C-Channels.
For each Interface Group, there will always be two C-Paths
for protection protcol when an active and a standby CChannel
are provisioned in protection group 1. The active and
standby C-Channels for the group 1 protection shall always
carry the two C-Paths for the protection protocol
respectively and the protection C-Paths shall not be
switched by the protection mechanism.
When an Interface Group has no protection group provisioned
in the v52CChannelTable, there will be no entries in this
table for this Interface Group."
REFERENCE
"Section 18.1.2, ETSI EN 300 347-1 V2.2.2 (1999-12)"
|
|
Disclaimer: The owner of this site does not warrant or assume any liability or responsibility for the accuracy, completeness, or usefulness of any information available on this page (for more information, please read the complete disclaimer).
All rights reserved © 2007-2024 |