|
|
Description:
|
mdmCCConnectionFailReason OBJECT-TYPE
SYNTAX INTEGER {
-- General
unknown(1), other(2), managementCommand(3), inactivityTimeout(4), mnpIncompatibility(5), protocolError(6),
-- DCE
powerLoss(10), equipmentFailure(11),
-- DTE Interface
dtrDrop(20),
-- Line Interface
noDialTone(30), lineBusy(31), noAnswer(32), voiceDetected(33),
-- Signal Converter
carrierLost(40), trainingFailed(41), faxDetected(42)}
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"Indicates the reason that the last connection or attempt failed. The meaning of each reason code is explained below.
unknown: This code means the failure reason is unknown or there has been no previous call.
other: This code used when no other code is applicable.
Additional vendor information may be available elsewhere.
managementCommand: A management command terminated the call. These commands include escaping to command mode, initiating
dialing, restoring lines, and disconnecting.
inactivityTimeout: The call was terminated because it was inactive for at the minimum duration specified.
mnpIncompatibility: The modems are unable to resolve MNP protocol differences.
protocolError: An error occured in one of protocol in use. Further information is required to determine in which
protocol the error occurred, and the exact nature of the error.
powerLoss: The modem lost power and disconnected the call.
equipmentFailure: The modem equipment failed.
dtrDrop: DTR has been turned off while the modem is to disconnect on DTR drop. (Ref: V.58 cct108TurnedOff) noDialTone: If the modem is to monitor for call progress tones, but the modem has failed to detect dial tone while
attempting to dial a number.
lineBusy: Busy signal is detected while busy signal detection is enabled, or while the 'W' or '@' dial modifier is used. (Ref: V.58 engagedTone)
noAnswer: The call was not answered.
voiceDetected: A voice was detected on the call.
carrierLost: Indicates that the modem has disconnected due to detection of loss of carrier. In TIA-602, the S10 register determines the time that loss of carrier must be detected before the modem disconnects.
trainingFailed: Indicates that the modems did not successfully train and reach data mode on the previous connection.
faxDetected: A fax was detected on the call."
REFERENCE
"V.58 callCleared"
|
|
|
|
Information:
|
Automatically extracted from IETF RFC 1696.
|
|
|
|
