|
|
Description:
|
phivAdjState OBJECT-TYPE
SYNTAX INTEGER {
initializing (1), -- Ethernet one-way
up (2), -- Ethernet two-way
run (3), -- The eight DDCMP/X.25 states
circuit-rejected (4),
data-link-start (5),
routing-layer-initialize (6),
routing-layer-verify (7),
routing-layer-complete (8),
off (9),
halt (10)
}
ACCESS read-only
STATUS obsolete
DESCRIPTION
"This value indicates the state of a router adjacency.
On adjacencies over a circuit of type
(phivCircuitCommonType) Ethernet, CI, or FDDI, with an
adjacent node of type (phivAdjType) ROUTING IV or AREA,
this variable is the state of the Ethernet
Initialization Layer for this adjacency, and can have
values INITIALIZING or UP. (See Section 9.1.1 of
DECnet Phase IV Routing Layer Functional Specification.)
On adjacencies over a circuit of type
(phivCircuitCommonType) Ethernet, CI, or FDDI, with an
adjacent node of type (phivAdjType) NONROUTING IV,
this variable will always take on the value UP.
On adjacencies over a circuit of type
(phivCircuitCommonType) DDCMP POINT, DDCMP CONTROL,
DDCMP TRIBUTARY, DDCMP DMC, or X.25, this variable is
the state of the Routing Layer Initialization Circuit
State. (See section 7.3, ibid.) It can have values
between RUN and HALT.
On adjacencies over a circuit of type
(phivCircuitCommonType) OTHER, this variable may be
used in a manner consistent with the Initialization
Layer used on that circuit."
|
|
Classification:
|
➵ Deprecated or obsolete OID
➵ MIB object for network management
|
|
See classes of OIDs
|
|
Information:
|
Automatically extracted from IETF RFC 1559.
|
|
|
|
