---
oid: "1.3.6.1.4.1.4491.2.1.16.1.1.1.8"
asn1-notation: "{iso(1) identified-organization(3) dod(6) internet(1) private(4) enterprise(1) 4491 clabProject(2) clabProjDocsis(1) teaPwTDMMIB(16) teaPwTDMObjects(1) teaPwTDMTable(1) teaPwTDMEntry(1) teaPwTDMCurrentIndications(8)}"
description: "teaPwTDMCurrentIndications OBJECT-TYPE"
classification: "MIB object for network management"
last-modified: "2020-01-29"
---

## OID : `1.3.6.1.4.1.4491.2.1.16.1.1.1.8`

```asn1
{iso(1) identified-organization(3) dod(6) internet(1) private(4) enterprise(1) 4491 clabProject(2) clabProjDocsis(1) teaPwTDMMIB(16) teaPwTDMObjects(1) teaPwTDMTable(1) teaPwTDMEntry(1) teaPwTDMCurrentIndications(8)}
```

### Description

```asn1
teaPwTDMCurrentIndications OBJECT-TYPE
SYNTAX BITS {
other ( 0),
strayPacket ( 1),
malformedPacket ( 2),
excessivePktLossRate( 3),
bufferOverrun ( 4),
bufferUnderrun ( 5),
remotePktLoss ( 6),
pktMisOrder ( 7),
packetLoss ( 8),
tdmFault ( 9)
}
MAX-ACCESS read-only
STATUS current
DESCRIPTION
"The following defects should be detected and reported
upon request:
-Stray packets MAY be detected by the PSN and multiplexing
layers. Stray packets MUST be discarded by the CE-bound IWF
and their detection MUST NOT affect mechanisms for detection
of packet loss.
-Malformed packets are detected by mismatch between the
expected packet size (taking the value of the L bit into
account) and the actual packet size inferred from the PSN and
multiplexing layers. Malformed in-order packets MUST be
discarded by the CE-bound IWF and replacement data generated
as for lost packets.
-Excessive packet loss rate is detected by computing the
average packet loss rate over the value of
teaPwTDMAvePktLossTimeWindow and comparing it with a
preconfigured threshold [RFC 4553].
-Buffer overrun is detected in the normal operation state
when the CE bound IWF's jitter buffer cannot accommodate
newly arrived packets.
-Remote packet loss is indicated by reception of packets with
their R bit set.
-Packet misorder is detected by looking at the Sequence
number provided by the control word.
-TDM Fault, if L bit in the control word is set, it indicates
that TDM data carried in the payload is invalid due an
attachment circuit fault. When the L bit is set the payload
MAY be omitted in order to conserve bandwidth.
Note: the algorithm used to capture these indications
is implementation-specific."
```

**Classification**: MIB object for network management

### Supplementary information

Automatically extracted from ASN.1 module [CL-PW-TDM-MIB](http://www.itu.int/ITU-T/formal-language/itu-t/j/j214/2007/CL-PW-TDM-MIB.html).

### Child OIDs

No child OID

### Terms of Use
[Terms of use](https://oid-base.com/disclaimer.htm.md)
