---
oid: "1.3.6.1.2.1.7.7"
asn1-notation: "{iso(1) identified-organization(3) dod(6) internet(1) mgmt(2) mib-2(1) udp(7) udpEndpointTable(7)}"
description: "udpEndpointTable OBJECT-TYPE"
classification: "MIB object for network management"
last-modified: "2019-07-05"
---

## OID : `1.3.6.1.2.1.7.7`

```asn1
{iso(1) identified-organization(3) dod(6) internet(1) mgmt(2) mib-2(1) udp(7) udpEndpointTable(7)}
```

### Description

```asn1
udpEndpointTable OBJECT-TYPE
SYNTAX SEQUENCE OF UdpEndpointEntry
MAX-ACCESS not-accessible
STATUS current
DESCRIPTION
"A table containing information about this entity's UDP
endpoints on which a local application is currently
accepting or sending datagrams.
The address type in this table represents the address
type used for the communication, irrespective of the
higher-layer abstraction. For example, an application
using IPv6 'sockets' to communicate via IPv4 between
::ffff:10.0.0.1 and ::ffff:10.0.0.2 would use
InetAddressType ipv4(1).
Unlike the udpTable in RFC 2013, this table also allows
the representation of an application that completely
specifies both local and remote addresses and ports. A
listening application is represented in three possible
ways:
1) An application that is willing to accept both IPv4
and IPv6 datagrams is represented by a
udpEndpointLocalAddressType of unknown(0) and a
udpEndpointLocalAddress of ''h (a zero-length
octet-string).
2) An application that is willing to accept only IPv4
or only IPv6 datagrams is represented by a
udpEndpointLocalAddressType of the appropriate
address type and a udpEndpointLocalAddress of
'0.0.0.0' or '::' respectively.
3) An application that is listening for datagrams only
for a specific IP address but from any remote
system is represented by a
udpEndpointLocalAddressType of the appropriate
address type, with udpEndpointLocalAddress
specifying the local address.
In all cases where the remote is a wildcard, the
udpEndpointRemoteAddressType is unknown(0), the
udpEndpointRemoteAddress is ''h (a zero-length
octet-string), and the udpEndpointRemotePort is 0.
If the operating system is demultiplexing UDP packets
by remote address and port, or if the application has
'connected' the socket specifying a default remote
address and port, the udpEndpointRemote* values should
be used to reflect this."
```

**Classification**: MIB object for network management

### Supplementary information

Automatically extracted from IETF [RFC 4113](https://www.rfc-editor.org/rfc/rfc4113.html).

### Child OIDs

- [OID `1.3.6.1.2.1.7.7.1`](https://oid-base.com/get-md/1.3.6.1.2.1.7.7.1): `udpEndpointEntry(1)`

### Terms of Use
[Terms of use](https://oid-base.com/disclaimer.htm.md)
